|
yup to both. still overhopped in the v2 I installed prior to nightfall... the patch was flat with the outer and no protrusion inside, but when installed into the hopup, the hop was always on... I aggressively went at the inner surface using the installation tool and some sand paper, we finally got acceptable results. We were using a prommy bridge nub which to me appeared to fit very tightly into the window, maybe too tightly soo maybe it was jamming in it and not releasing properly when adjusting the wheel.
I did another v3 the night before we left and it's shooting beautifully, though I sanded the fuck out of it both surfaces to make sure there was good clearance. This one was set to use a standard cylindrical nub.
__________________
I futz with V2s, V3s and V6s. I could be wrong... but probably, most likely not, as far as I know.
|