Airsoft Canada - View Single Post

mcguyver · April 17th, 2008, 18:43

I guess you should specify if you have the 490 motor or not. With the 480, routing wiring was not as critical, as the brush hoods are different and the brush leads are routed in a different fashion as well.

A note on soldering, go easy. You don't need to heat the terminals up until they're blue and you only need a bit of solder. Don't goop the shit on.

If you have a 480 motor, the bearing is necessary to adjust the motor height. It is not required for the 490, as they are not adjustable.

April 17th, 2008, 18:43	#46
mcguyver Trader rating Join Date: Aug 2005 Location: Northern Alberta	I guess you should specify if you have the 490 motor or not. With the 480, routing wiring was not as critical, as the brush hoods are different and the brush leads are routed in a different fashion as well. A note on soldering, go easy. You don't need to heat the terminals up until they're blue and you only need a bit of solder. Don't goop the shit on. If you have a 480 motor, the bearing is necessary to adjust the motor height. It is not required for the 490, as they are not adjustable. __________________ Age verifier Northern Alberta Democracy is two wolves and a sheep discussing what's for dinner. Freedom is the wolves limping away while the sheep reloads. Never confuse freedom with democracy.