[Hauptmann Dosman]

Thanks for the help with that problem guys, but now I run into another problem.
When I then install the chamber, tappet plate, etc into the box and replace the spring on the tappet it causes it to sit like picture 1. Now I can press the nozzle when putting everything back together so that the tappet sits like pic 2. However this causes the nozzle to not be in the full forward position(pic 3), and I believe that this may have caused some feed/jamming issues that I had before.
So my question is, am I wrong about the tappet/nozzle position causing me issues, or would turning the sector gear so that everything rests properly (tappet full forward) be better?